To Next PageTo Next Page
Need help?Do you have a question about the Corsair XT HARDLINE and is the answer not in the manual?
Insert the silicone rod into the hardline tubing, ensuring part of it protrudes for later removal.
Heat the tube evenly with a heat gun set to 250-300°C, rotating it to bend.
Wash tubes with warm water and rinse with distilled water; anneal tubing to normalize internal stress.
Clarifies compatibility with different tube sizes, materials (PMMA, PETG), and brands.
Addresses the possibility and recommendation of reheating and correcting tube bends.
General| Material | PMMA |
|---|---|
| Outer Diameter | 14 mm |
| Inner Diameter | 10 mm |
| Length | 500 mm |
| Wall Thickness | 2mm |
| Type | Hardline Tubing |
| Color | Clear |
