4. Screw the regulator cap back into the regulator and reattach the regulator to the
STEP 2 - CHANGE BURNER ORIFICES
IMPORTANT:
the Burner Chart earlier in this section.
NOTE:
possibility that some may not be replaced.
1. Remove the burner grates, burner caps and burner heads.
2.
a
a
Triple Ring Burner
5
Auxiliary Burner
Semi-Rapid Burner
Rapid Burner
1 Each
3.
4.
5.
6.
7.
R
eplace the burner bases
, heads, caps and top grates. Make sure burner caps are
Check whether the nozzle was installed in the proper position.
Check whether the gas supply is correct.
Check whether the regulator valve has been replaced.
Save the orifices removed from the appliance for future use.
Caution: The gas supply should be shut off prior to disconnecting the electrical power,
before proceeding with the conversion.
properly seated on the burner head.
33
To Next Page
Loading...
