18
WARNING: Improper connection of the equipment-grounding conductor can
result in a risk of electric shock. Check with a qualified electrician or service
technician if you are in doubt as to whether the appliance is properly
grounded. Do not modify the power supply cord plug. If it will not fit the
outlet, have a proper outlet installed by a qualified electrician.
ELECTRICAL CONNECTION
• The receptacle of this range is to be connected to a properly grounded
dedicated circuit providing 120 VAC/60 Hz power and protected by a 15-
or 20-Amp circuit breaker or slow blow fuse. It is recommended that a
separate circuit serving only this range be provided.
• Where a standard two-prong wall receptacle is encountered, contact a
qualified electrician to have it replaced with a properly grounded three-
prong wall receptacle.
• This range is equipped with an electronic ignition system that will not
operate properly if plugged into an outlet that is not correctly polarized.
• Electronic ignition systems operate within wide voltage limits, but proper
grounding and polarity are necessary. Check that the outlet provides 120-
volt power and is correctly grounded.
• Do not use an extension cord or an adapter plug.
• Check local codes and consult gas supplier. Check existing electrical
supply and gas supply. It is recommended that all electrical connections
be made by a licensed, qualified electrical installer.
• Range must be connected to the proper electrical voltage and frequency
as specified on the model/serial/rating plate. The plate is located on the
back panel of the range.
• It is the personal responsibility of the range owner to provide the correct
electrical service for this range.
• This gas range is not required or recommended to be plugged into a GFCI
(Ground-Fault Circuit Interrupter) outlet. It is recommended that you not
plug an electric spark ignition gas range or any other major appliance
into a GFCI wall outlet as it may cause the GFCI to trip during normal
cycling.
• Performance of this range will not be affected if operated on a GFCI-
protected circuit. However, occasional nuisance tripping of the GFCI
breaker is possible due to the normal operating nature of electronic gas
ranges.
• The wiring diagram is located on the back of the range.
To Next Page
Loading...
Need help?
General
