9
LOCATION REQUIREMENTS
IMPORTANT: Observe all governing codes and ordinances. Do not obstruct
flow of combustion and ventilation air.
• It is the installer's responsibility to comply with installation clearances
specified on the model/serial/rating plate. The model/serial/rating plate
is located on the back panel of the range.
• The range should be located for convenient use in the kitchen.
• Recessed installations must provide complete enclosure of the sides and
rear of the range.
• Do not install a ventilation system that blows air downward toward the
range.
• Do not locate the range where it may be subject to strong drafts.
• All openings in the wall or floor where range is to be installed must be
sealed.
• Do not seal the range to the side cabinets.
• Cabinet opening dimensions that are shown must be used.
• The anti-tip bracket must be installed.
• Grounded electrical supply is required. See "Electrical Requirements"
section.
• Proper gas supply connection must be available. See "Gas Supply
Requirements" section.
• Stylish color handle & knob kits
• LP conversion kits
Optional Parts
To purchase these or any other accessories or replacement parts, please visit
www.cosmoappliances.com or reference the contact information at the end
of this manual.
Scan to find
available LP kits
Scan to find
available
handle & knob
kits
To Next Page
Loading...
Need help?
General
