25
UNPACK RANGE
1. Remove all tape and packaging materials. Check for film on stainless
steel parts, padding/spacers on and around door and face of oven,
cardboard and plastic on and around racks, etc. Do not dispose of
anything until the installation is complete.
NOTE:
• Do not use sharp instruments, rubbing alcohol, flammable fluids, or
abrasive cleaners to remove tape or glue. These products can
damage the surface of your range.
• To reduce the weight of the range while being moved, adjusted,
and installed, leave the cooktop grates, cooktop burners, oven
racks, and any other accessories to the side until they are ready to
be installed later in these instructions.
• To further reduce the weight of the range while being moved,
adjusted, and installed, detach the oven door from the range. See
"Removing/Assembling Oven Door" section.
WARNING
EXCESSIVE WEIGHT HAZARD
• Use two or more people to move and install range. Failure to do so can
result in back or other injury.
To Next Page
Loading...
Need help?
General
