Cosmopolitan Phoenix Omnivue Series - Component Installation and Setup; Installing Side Glass; Installing Front Glass; Installing Optional Wall Mounted Touch Control

9
Installing Side Glass Installing Optional Wall Mounted Touch Control
Wi-Fi InstructionsInstalling Front Glass
1. Locate 2-gang low voltage bracket
within 20 feet (6m) of replace.
Install according to manufacturer’s
instructions.
2. Remove glass face (attached with
magnets) from metal bracket.
3. Attach the metal bracket to the low
voltage bracket with the included
screws.
4. Insert batteries (2 AAA) and replace the
glass face.
Scan the QR code for step by step
instructions to setup Wi-Fi
1. The unit has 2 channels on the top and bottom to hold the
side glass.
2. Insert the glass at an angle in to the top channel.
3. Swing the bottom edge of the side glass in to the unit.
See Figure 1.1.
4. Slide the glass down in to the bottom channel.
5. Push the glass back as far as it will go to make
installation of the front glass easier. See Figure 1.2.
1. The unit has 2 channels on the top and bottom to hold the
front glass.
2. Using the included suction cups, insert the glass at an
angle in to the top channel.
3. Swing the bottom edge of the front glass in to the unit.
See Figure 2.1.
4. Slide the glass down in to the bottom channel. See Figure
2.2