Cotes C35 - Additional Information for a C35 C Dehumidifier (Cold Store Model)

COTES C35 OPERATING AND SERVICE HANDBOOK page 35/71
Safety precautions
Dehumidifiers in the C35 range weigh approximately 102–115 kg and should therefore only be
moved using a forklift or similar equipment
Any work in the electrical box should only be carried out by authorised electricians.
Any duct connections to and from the dehumidifier should only be carried out by authorised
plumbers.
ADDITIONAL INFORMATION FOR C35C DEHUMIDIFIERS
(COLD STORE MODEL)
Where to mount this dehumidifier
Cotes C35C adsorption dehumidifiers are specially designed for installation inside cold storage
facilities.
Where not to mount it
The unit must not be installed outside the cold storage space unless this has been arranged with
Cotes and special adjustments have been made to the unit.
Connections needed – electrical
First, make sure that the 1kW external heater is connected to 230V/50Hz and the external control
current is connected to the electrical board, as described in the electrical diagram on page 300 for the
C35C cold storage model. The external heater pre-heats the regeneration air before it enters the
C35C dehumidifier.
The C35C electrical cabinet has a small built-in fan heater to protect all the electrical components
from the cold storage temperatures. The fan heater operates for 30 minutes before the dehumidifier
starts, as a safety precaution when the main switch is on.
NOTE
The C35C dehumidifier has a built-in fan heater in order to protect the electrical
components. A 30-minute timer is activated when the main switch is turned on.