Courion iLEARN - Iwire Package Provided by Courion

5
ver.071217-2.10
iLEARN System Manual
iWIRE Package Provided By Courion
COURION’s Next Generation System includes the following pre-numbered and color-coded wiring
bundles -
• iWIRE Motor Wiring Bundle (#90-947400) - Four (4) wire hoistway motor cable in an amount sufcient
to wire the COURION Door Motors, Gate Drives, and Retiring Cam Motors to the iDRIVE VFD Controls
located at each oor or car top.
• iWIRE CANbus Cable (#90-947405) - Two (2) twisted pair communication wires and a drain wire in an
amount sufcient to wire the iLEARN Door Control to all iDRIVE VFD Floor an Gate Controls.
• iWIRE Hoistway Cable (#90-947409) - Five (5) shielded 16 AWG insulated power wires, one (1) yellow 18
AWG insulated wires for the CANbus Address In/Address Out Input, and three (3) black 18 AWG insulated
wires as spares.
• iWIRE Floor/Gate Wiring Bundle (#90-947415) - Fifteen (15) 18 AWG insulated wires in an amount suf-
cient to wire the Door Push Buttons, EUDs, and Floor Zone Switches to the iDRIVE VFD Controls located
at each oor or car top.
• iWIRE Traveling Cable (#90-947416) - Four (4) twisted pair shielded serial CANbus communication wires,
ve (5) 16 AWG insulated power wires, and three (3) 18 AWG insulated wires as spares.
• iWIRE Interconnection Wiring Bundle (#90-947423) - Three (3) 16 AWG insulated power wires, and
twenty (20) 18 AWG insulated wires in an amount sufcient to run from COURION’s iLEARN Door Control
to the Elevator Control. When wiring the inter-control interface between COURION’s iLEARN Door Control
and the Elevator Control, please refer to the Elevator Control Wiring Schematics and COURION’s Inter-
control Interface Circuit Descriptions in this book for more details.
• iWIRE Hoistway Junction Box, Traveling Cable Junction Box, and Two (2) Flat Traveling Cable Grips
(#01-929200 & #01-929201)