Cove DW2450 - Page 56


828019 REV B 08/2023
DW2450 and DW2450WS Service Manual
service.subzero.com 800.222.7820
Base Component Removal and Installation
FRONT THERMAL CUTOUT AND BRACKET REMOVAL
WARNING
Disconnect the product from the power source
before starting this procedure.
To remove the front thermal cutout, first remove:
Door panel
Kickplate
Lower front cover
Upper front cover
Lower rack
Lower spray arm
Sump filter screen and fine filter
Use a wet vacuum to remove water from the sump. Then,
disconnect the temperature and turbidity sensor wire
connectors.
REMOVE THE FRONT THERMAL CUTOUT AND
BRACKET
CAUTION
Before proceeding, use the digital multimeter to
check for voltage on both heater element
terminals. If there is any voltage, the power is not
completely disconnected. Make sure the power is
completely disconnected before proceeding to
avoid personal injury or damage to the product.
Use a hand driver and T-20 driver to remove the two
screws holding the front TCO bracket in place.
Slide the bracket off the sensor.
TIP: Be careful to avoid disturbing the sensor.
1
2
3
4
5
6
7
1
2
56