10
English
PRODUCT INSTALLATION
Installing the Product
No. Explanation Reference picture
1 Close main water supply valve to separate the faucet.
2
Wind the teon tape on the adaptor and t it to the pipe.
Do not tum the water pipe.
3
Connect the faucet with the adaptor.
Shall install the adaptor with connector on the cold water
pipe.
4
Connect ¼ inch orange tubing with the connector on the
adaptor.
Flush water through each filter at least
5 minutes before connection.
5
Connect it to voltage rating that matches it on the rating
plate. Then, open the feed valve to supply water to the
filtration system.
To Next Page
Loading...
