13
13
HOW TO OPERATE
Light Sensor Setting Function
Quantative Extraction Function
Light Sensor Setting Function Press the hot water mode selection button and cold water mode
selection button together for three seconds, the hot water mode selection indicator flickers with
a “pinging” sound, and the system enters the setting mode.
Press the cold water mode selection button once, the cold water mode selection indicator comes
on, and the light sensor function is set.(When the cold water mode selection indicator goes out,
the function is disabled.) After setting the mode, press the ambient water mode selection button
for three seconds, the system saves the last set mode and converts to standby mode.
Press the hot water mode selection button and cold water mode selection button together
for three seconds, the hot water mode selection indicator flickers with a “pinging” sound, and
the system enters the setting mode. The quantity is adjusted each time the hot water mode
selection button is pressed(about 120 cc → 200 cc → 300 cc → 120 cc), and the hot water
temperature indicator goes on according to each quantity phase.
After setting the mode, press the ambient water mode selection button for three seconds, the
system saves the last set mode and converts to standby mode.
- To use both the hot water and cold water modes, press each button for
more than three seconds. Once both hot water and cold water mode lamp go on,
you can use them.
- “Light sensor” is set to disabled status at the initial usage.
If you check the cold water temperature indicator and press the extraction button by selecting
the cold water button, about 1 cup of the cold water (paper cup basis) is extracted.
When you press the extraction button again during the extraction, the extraction is stopped.
To Drink Cold Water
If you select the hot water button after checking the hot water temperature indicator and press
the extraction button, about 1 cup of the hot water (paper cup basis) is extracted.
When you press the extraction button again during the extraction, the extraction is stopped.
To Drink Hot Water
When you select the ambient water button and press the extraction button, about 1 cup of the
ambient water (paper cup basis) is extracted.
When you press the extraction button again during the extraction, the extraction is stopped.
To Drink Ambient Water
When the cold water does not extract from the product, please check if the cold water
mode selection indicator is on.
If you press the extraction button (about 3 seconds) longer by selecting the wanted water
(cold water/hot water/ambient water), you can extract the selected water continuously with blinking
the extraction part indicator.
If you press the extraction button again during the continuous extraction, the extraction is stopped.
Continuous Extraction
Tips
Tips
To Next Page
Loading...
Need help?
General
