PRODUCT INSTALLATION
■ Cleaning the Neo Sense filter 8 inch (S) (for installation and replacement):
Clean the Neo Sense filter 8 inch (S) for about 30 seconds.
■ Cleaning the Post Carbon block filter 8 inch (S) (for installation and replacement):
Clean the Post Carbon block filter 8 inch (S) for about 3 minutes.
For initial installation, flush the Post Carbon block filter 8 inch (S) before installing it.
(Flushing the Post Carbon block filter 8 inch (S) during the initial installation minimizes the inflow of
fine particles into the water tank.)
■ Cleaning the Neo Sense filter and Post Carbon block filter
Remove the tubing from the bottom of the Neo Sense filter 8 inch (S).
Connect the Post Carbon block filter 8 inch (S) to the bottom of the Neo Sense filter 8 inch (S).
Clean the Post Carbon block filter 8 inch (S) with the water coming from the Neo Sense filter
8 inch (S) for about 3 minutes. (Water flow rate 300~500 ㎖ /min)
Separate the Post Carbon block filter 8 inch (S) from the Neo Sense filter 8 inch (S) and then
connect it to the bottom of the Membrane filter (RO) 8 inch.
1. Precautions on installation
Installation Method
Installing the Product
Inlet tubing (Orange)
Cooling stopper
Outlet tubing (Blue)
Main water supply
valve
To Next Page
Loading...
Need help?
General
