8
English
PRODUCT INSTALLATION
Installation Materials
1. Accessories
1. Precautions on installation
■ The water tank capacity of this water purification system is designed for home use.
It is prohibited to install the system for medium/large business or public use.
(If the water purification system is used beyond its capacity, water shortage and/or shortened
filter life may occur as a result.)
■ Install the product at least 10 cm away from the wall and on a firm and level floor.
■ Installation water pressure
The feed water supply pressure should be at least 20 psi for the purification system to work
properly, providing enough filtered water.
■ Installation distance from tap water supply
Feed water pressure 20 psi or higher: Install the system in a place within a range of 3M in height
and 25M in distance.
■ Do not install the system in a place where it is subjected to direct sunlight, freezing temperature,
and/or excessive moisture.
■ In the case the system is newly installed or relocated, read the User’s Manual once again before
installation.
■ This product is for 220 V - 240 V 50 Hz Make sure to check the rated voltage before connect
the power cord to the electrical outlet.
■ Make sure to connect the feed water inlet hose to the cold water piping.
In the case the feed water inlet hose is connected to warm water piping with the water
temperature of 40 °C or higher, filters may be damaged.
■ Right after the installation, fill up the water tank and drain the water.
Repeat it at least twice before use.
Installation Method
Owner’s Instructions Installation book
Orange and blue tube set
Drain Hose
Water supply valve
Adaptor
Cooling Stopper
To Next Page
Loading...
Need help?
General
