2
English
• Right after the installation, fill up the water tank and drain the water. Repeat it at least twice
before use.
• If water has been stored in the water tank for a long time without using the unit, completely drain
the water and clean the tank. In the case the tank cannot be cleaned, drain the water once again
before use.
• In order to have filtered potable water, replace filters regularly.
If filters are overused beyond their service life, the quality of the filtered water may deteriorate.
• Keep the surrounding areas neat and clean the inside of the water tanks once every two months.
• Do not place a heavy object or exert excessive pressure on the top of the product.
• Do not exert excessive shock on the product.
Precautions on Use
Precautions on Installation
• Do not install the product where the unit is exposed to direct sunlight or heating devices.
Otherwise product deformation or fire may occur as a result.
• Do not install the unit in areas where moisture, water (rainwater) is present.
Otherwise electric shock or fire may occur as a result.
• Do not operate the unit in areas where flammable gases or combustible materials are used
or stored. Otherwise fire may occur as a result.
• Install the unit on a level area and do not exert excessive force or shock on the unit.
Otherwise product damage or malfunction may occur as a result.
• Use tap water as feed water.
• Do not connect the water inlet to the warm water supply piping.
Otherwise malfunctions or accidents may occur as a result. (Make sure to connect to cold tap water
suppy piping.)
• The length of the water inlet hose must be 5 m or less.
If it is longer, it may degrade the product’s performance.
• The length of the water outlet hose must be 25cm or less.
If it is longer, it may degrade the product’s performance, and prevent complete drainage of water.
• Proper places to install the unit
Install the unit firmly on a level area. If the unit is installed in an unstable place, the system may not
function properly.
• Do not plug into an outlet or power strip that is being used by several other appliances.
Use an outlet dedicated to the unit.
Otherwise fire may occur as a result.
• Do not attempt to repair or modify the power cord.
Otherwise electric shock or fire may occur as a result.
• Remove any dust or water off the power plug.
Otherwise electric shock or fire may occur as a result.
• Do not plug and unplug the unit repeatedly.
Otherwise electric shock or fire may occur as a result.
• If the electric outlet is wet, carefully unplug the unit and let the electric outlet completely dry before
subsequent use. Otherwise electric shock or fire may occur as a result.
To Next Page
Loading...
Need help?
General
