12
For Information
WATER FILTRATION PROCESS / INSTALLATION PRECAUTIONS
INSTALLATION PRECAUTIONS
P-07FR/FRV
1. Wind the teon tape on the adapter and t it to the
pipe.
2. Connect orange tubing with the connector on the
adapter.
3. Make a hole on the drain pipe and install the drain
clamp on the hole.
4. Connect the extraction tting to the faucet with a
tube.
5. Connect the orange colored inlet tubing for the feed
water with the cold water pipe.
Extend the blue color outlet tubing to where the drain
is.
6. Connect it to voltage rating that matches it on the
rating plate. Then, open the feed valve to supply
water to the ltration system.
7. The nished image.
Shall install the adapter with connector on the cold water
pipe.
Drain water for more than 8 minutes before use.
After ushing 8 minutes, the ltered water will be
suitable for consumption.
WQA Approved NSF/ANSI 42/53/58 MH 01/24/2011
To Next Page
Loading...
Need help?
General
