To Next Page

To Previous Page

PROGRAMMING TV/VCR COMBO CONTROL

(continued)

5. If you’ve located a TV/VCR setup code that

works your TV/VCR Combo and a separate TV

code is also listed, you’ll need to program this

code into the remote control to access volume

control (see Programming Device Control on

page 8).

If there is no separate TV code listed, you will

need to perform the following steps to access

volume control:

a. Press and hold SETUP until the VCR key

blinks twice, then release SETUP.

b. Enter 9 - 9 - 3.The VCR key will blink twice.

c. Press VCR once. The VCR key will blink

twice.

6. For future reference, write down each working

device code in the boxes below:

TV/VCR

TV (if used)

Cox Manual 11/27/01 7:14 PM Page 10

Questions and Answers:

Need help?

Do you have a question about the COX universal remote control and is the answer not in the manual?

COX universal remote control Specifications

General