27
3. Press VCR once. It will blink twice.
4. Now, whenever you press VOL+,VOL-,or
MUTE, volume will be controlled by your VCR.
To change Volume Lock to AUX mode:
NOTE: Performing these steps will allow you to access the volume
control of your auxiliary device in all modes.
1. On the remote control, press AUX once.
Then press and hold SETUP until the
AUX key blinks twice, then release SETUP.
2. Enter 9 - 9 - 3.The AUX key will blink twice.
3. Press AUX once. It will blink twice.
4. Now, whenever you press VOL+,VOL-,or MUTE,
the volume will be controlled by your
auxiliary device.
TROUBLESHOOTING
PROBLEM: Mode key does not blink when you press a key.
SOLUTION: Replace the batteries with two (2) new AA
alkaline batteries (see page 7).
PROBLEM: Mode key blinks when you press a key, but home
entertainment device does not respond.
SOLUTION: Make sure you are aiming the remote control at
your home entertainment device and that you
are within 15 feet of the device you are trying
to control.
PROBLEM: The remote control does not control home enter-
tainment devices or commands are not perform-
ing properly.
SOLUTION: Try all listed codes for the device brand being set
up. Make sure all devices can be operated with
an infrared remote control.
PROBLEM: TV/VCR combo does not respond properly.
SOLUTION: Use the VCR codes for your brand. Some combo
units may require both a TV code and a VCR
code for full operation (see page 9).
PROBLEM: No volume on a second TV.
SOLUTION: Follow instructions in Changing Volume Lock
(see previous page).
continued on the next page...
To Next Page
Loading...
