COX universal remote control User Manual

22
PROGRAMMING ID LOCK
The Cox Universal Remote Control is preprogrammed and
locked at the factory to operate the cable converter and
interactive service given to you by your cable company.
However, if you have another brand or model of cable
converter and interactive service that you would like to
control,then you’ll need to perform the following steps to
unlock the cable ID Lock, enter in a new manufacturer’s
code, and lock the ID Lock again.
1. Turn on the Cable Converter.
2. On the remote control, press CABLE once.
Then press and hold SETUP until the
CABLE key blinks twice, then release SETUP.
3. Enter 9 - 8 - 2.The CABLE key will blink
four times.
4. Perform the instructions in Programming
Device Control on page 8 to program device
control for the desired cable converter and
interactive service. Upon completion, perform
the remaining steps (5 and 6 on this page) to
again lock the ID lock.
5. On the remote control, press CABLE once.
Then press and hold SETUP until the
CABLE key blinks twice, then release SETUP.
6. Enter 9 - 8 - 2.The CABLE key will blink twice.
Cox Manual 11/27/01 7:14 PM Page 22

COX universal remote control Specifications

General

Brand	COX
Model	universal remote control
Category	Remote Control
Language	English