it can discharge the current to the ground to guarantee the device proper work. The
signal lightning arrester has many specifications, and widely used in many devices such
as telephone, network, analog communication, digital communication, cable TV and
satellite antenna. For all the input port, especially those from the outdoor, you need to
install the signal lightning arrester.
Antenna feed cable lightning arrester: It is suitable for antenna system of the transmitter
or the device system to receive the wireless signal. It uses the serial connection too.
Please note, when you select the lighting arrester, please pay attention to the port type and
the earthing reliability. In some important environment, you need to use special shielded
cable. Do not parallel connect the thunder proof ground cable with the ground cable of the
lightning rod. Please make sure they are far enough and grounded respectively.
2. The earthing modes
We all know the earthing is the most complicated technology in the electromagnetism
compatibility design since there is no systematic theory or module. The earthing has many
modes, but the selection depends on the system structure and performance. The following
are some successfully experience from our past work.
One-point ground: In the following figure you can see there is a one-point ground. This
connection provides common port to allow signal to be transmitted in many circuits. If there is
no common port, the error signal transmission occurred. In the one-point ground mode, each
circuit is just grounded only and they are connected at the same port. Since there is only one
common port, there is no circuit and so, there is no interference.
Multiple-point ground: In the following figure, you can see the internal circuit uses the
chassis as the common point. While at the same time, all devices chassis use the earthing
as the common port. In this connection, the ground structure can provide the lower ground
resistance because when there are multiple-point grounds; each ground cable is as short as
possible. And the parallel cable connection can reduce the total conductance of the ground
conductor. In the high-frequency circuit, you need to use the multiple-point ground mode and
each cable needs to connect to the ground. The length shall be less than the 1/20 of the
signal wavelength.
To Next Page
Loading...
