2.6.6 Display
It is to set display output mode. There are two modes: full screen (4:3)/image original rate
(16:9). Icon means current display output mode. See Figure 2-35.
Figure 2-35
2.6.7 Search
Please refer to chapter 2.10.1 for detailed information.
2.6.8 Record Control
Please refer to chapter 2.12.3.4 for detailed information.
2.6.9 Remote Device
Please refer to chapter 2.10.3.1 for detailed information.
2.6.10 Main menu
Please refer to chapter 2.9 for detailed information.
2.7 Navigation Bar
You need to go to the Main Menu Setting System General to enable navigation bar
function; otherwise you cannot see the following interface. The navigation bar is shown as
below. See Figure 2-36.
To Next Page
Loading...
