USER MANUAL
10
www.CookingPerformanceGroup.com
INSTALLATION INSTRUCTIONS
THESE UNITS ARE SUITABLE FOR INSTALLATION ON NON-COMBUSTIBLE
SURFACES ONLY. DO NOT INSTALL NEAR ANY COMBUSTIBLE SURFACES.
Combustible Clearance Requirements: 6” sides, 6” back
IMMEDIATELY INSPECT FOR SHIPPING DAMAGE:
All containers should be examined for damage before and during unloading. The freight carrier has assumed responsibility for
its safe transit and delivery. If equipment is received damaged, either apparent or concealed, a claim must be made with the
delivering carrier.
Apparent damage or loss must be noted on the freight bill at the time of delivery. It must then be signed by the carrier
representative (ie: driver). If th
is is not done, the carrier may refuse the claim. The carrier can supply the necessary forms.
Concealed damage or loss if not apparent until after equipment is uncrated, a request for inspection must be made to the
inspection. Be certain to hold all contents and packaging material.
Installation and service should be performed by an authorized service agency. If you have questions concerning the installation,
operation, maintenance or service of your equipment, visit CPG’s website at www.CookingPerformanceGroup.com.
accessories. Adequate clearance should be provided for proper operation and servicing. Level the commercial range once
you’ve uncrated it in your facility using the adjustable feet.
Proper ventilation is crucial to safe and optimum performance. Ensure that the oven is installed underneath a ventilation hood
according to all applicable local and national codes. Keep adequate clearance for air openings into the combustion chamber.
GAS CONNECTION
NOTE:
that is lower than 2,000 feet.
1. Ensure gas supply and gas type, as shown on unit serial plate agree. Unit installation must conform with the National
Fuel Gas Code, ANSI Z223.1/NFPA 54, the National Gas Installation Code, CSA-B149.1, or the Propane Installation Code,
CSA-B149.2 as applicable and in accordance with local codes.
2.
for safety and ease in servicing.
3. The gas pressure regulator supplied must be installed on the appliance prior to connecting the equipment to the gas
line. Failure to install a regulator could be potentially hazardous and will void limited equipment warranty.
4.
CAUTION: Do NOT
prior to operating unit.
To Next Page
Loading...