CRADLEPOINT COR | USER MANUAL Firmware ver. 5.0.0
© 2013 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 110
Ethernet Port Configuration
Ethernet Port Configuration provides
controls for your router’s Ethernet ports.
There are two ports: one set as LAN and
one set as WAN. While default settings will
be sufficient in most circumstances, you
have the ability to control: Mode (WAN or
LAN) and Link Speed. Additional controls
for WAN ports are available in Internet →
Ethernet Settings.
Mode: WAN or LAN.
• Internet (WAN) is used to connect to another network such as a hotel or office wired network. The WAN
connection is used as a possible source of Internet for the router.
• Local Network (LAN) is for connecting a computer or similar device directly to the router with an Ethernet cable.
Link Speed: Default setting is Auto. The Auto setting is preferred in most cases.
• Auto
• 10Mbps - Half Duplex
• 10Mbps - Full Duplex
• 100Mbps - Half Duplex
• 100Mbps - Full Duplex
• 1000Mbps - Full Duplex
To Next Page
Loading...
