CRADLEPOINT COR | USER MANUAL Firmware ver. 5.0.0
© 2013 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 150
Condition: Select “is,” “is not,” “starts with,” “contains,” or “ends with” to create your condition’s statement.
Value: If the correct values are available, select from the dropdown list. You may need to manually input the value.
The condition will be of the following form:
“ (When) is/is not (value) ”
For example:
“Type is not WiMAX”
“Port is Internal USB Port”
Once you have established the condition for your configuration rule, choose from the other tabs to set the desired
configuration. All of the tab options – General Settings, IP Overrides, IPv6 Settings, Ethernet Settings, Modem
Settings, WiMAX Settings, CDMA Settings, and SIM/APN/Auth Settings – have the same configuration options shown
above in the WAN Configuration section (the options for Configuration Rules are the same as they are for individual
devices).
To Next Page
Loading...
