Cradlepoint MBR95 - WiFi; Local Networks

CRADLEPOINT MBR95| USER MANUAL Firmware ver. 3.6.3
 NETWORK SETTINGS → WIFI / LOCAL NETWORKS
© 2011 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 66
6.7 WiFi / Local Networks
This section is used to configure the settings for
wireless networks created by your router. Note
that changes made in this section may also need
to be duplicated on wireless devices that you
want to connect to your wireless network.
For example, if you change a LAN’s IP address, devices
within that network will lose connection. They will have to
reconnect to the network.
The user can set up multiple networks, each with
its own unique configuration and its own selection
of interfaces. Each local network can be attached
to either of the following types of interfaces:
 WiFi
 Ethernet
For example, one network might be just an isolated WiFi hotspot for guests, while another might be the main network with administrative access,
two Ethernet ports, and a password-protected WiFi SSID.
6.7.1 Local IP Networks
Local IP Networks displays the following
information for each network:
 Network Name
 IP address/Netmask
 DHCP Server (Enabled/Disabled)
 Routing Mode (NAT, Standard, Disabled)
 Access Control (Admin Access, UPnP Gateway, LAN Isolation)
 Attached Interfaces (Ethernet ports, WiFi)