CRADLEPOINT MBR95| USER MANUAL Firmware ver. 3.6.3
NETWORK SETTINGS → WIFI / LOCAL NETWORKS
© 2011 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 73
6.7.3 Local Network Interfaces
Each LAN type—WiFi and Ethernet—has a separate section with configuration options. Unless the default configuration is
sufficient, YOU MUST CONFIGURE EACH INTERFACE SEPARATELY in order to create the desired interface options
for a network. You can then select these interfaces to add to a network in the Local Network Editor (see above).
Select from the following tabs:
Wireless (WiFi) Network Settings
Ethernet Port Configuration
Wireless (WiFi) Network Settings
The MBR1400 can broadcast as many as four SSIDs (service set identifiers — the names for WiFi networks). One
primary WiFi network is enabled by default, while you may have enabled a second guest network when using the First
Time Setup Wizard. You have the ability to change the settings for either of these networks and/or enable two additional
networks.
Wireless Radio: Enable/Disable. (Default: Enabled). Leave enabled unless you don’t want any WiFi networks broadcast
from your router.
Select a WiFi network and click
Edit to change the settings.
To Next Page
Loading...
