To Next Page

To Previous Page

Figure 57

6. Install a router bit with a

bearing guide as directed by the

router manufacturer’s instructions,

then with the router lift, raise it to

the desired height. (Fig.58)

Figure 58

7. Rest the workpiece against the

starting pin, reconnect the power and

turn on the router. Slowly pivot and

feed the workpiece into the router

bit. After the cut is started, move the

workpiece against the guide bearing

and away from the starting pin.

MAINTENANCE

For a clean and safe router table

operation you should vacuum off

excess sawdust, wipe down the table

with a dry cloth to remove any

residual dust not captured by the

vacuum. And check weekly for the

following possible problems:

• Loose router clamping plates

• Loose table insert fasteners

• Loose stand and table

fasteners

• Worn or damaged cords/plugs

(replace if necessary)

Craftex CX418 Manual

Other manuals for Craftex CX418