Craftex CX503 User Manual

5
MODEL CX503 – METALWORKING SANDER
As part of the growing line of Craftex metalworking equipment, we are proud to offer the
CX503 a Metalworking Sander. The Craftex name guarantees Craft Excellence. By following
the instructions and procedures laid out in this user manual, you will receive years of excellent
service and satisfaction. The CX503 is a professional tool and like all power tools, proper care
and safety procedures should be adhered to.
Motor Type .....................................TEFC
Motor Horsepower..........................2-HP
Motor Phase & Voltage...................Single Phase 220-Volt
Amperage.......................................10-Amps
Bearings .........................................Sealed and Permanently Lubricated
Cycle & RPM .................................. 60 Hertz and 3400 RPM
Sanding Belt Size ...........................3” x 78”
Contact Wheel Diameter ................7-3/4” (195mm)
Contact Wheel Surface...................Rubber
Sanding Belt Speed........................35 m/s
Sanding Belt Tilt ............................. 0 – 60-degree
Height.............................................19”
Width ..............................................27”
Length ............................................44”
Weight ............................................158 lbs, 72 Kg
Warranty.........................................3-Year
CX503 – METALWORKING SANDER
FEATURES

Craftex CX503 Specifications

General

Brand	Craftex
Model	CX503
Category	Sander
Language	English