7
SETUP
Before setting up your machine you must
read and understand the instructions given
in this manual.
When setting up your machine, you will
want to find an ideal spot where your
metalworking sander will be located most of
the time.
Figure-1 Minimum workspace for CX503
UNPACKING
To ensure safe transportation this machine
has been properly packaged and shipped
completely in a crate. When unpacking,
carefully inspect the crate for any damage.
Open the crate and check that the machine
and parts are in good condition.
Figure-2 Inventory
LIST OF CONTENTS QTY
A. Metalworking Sander ...................... 1
B. Stand ............................................... 1
C. Front Dust Port................................. 1
D. Tool Rest ......................................... 1
E. Eye Shield........................................ 1
F. Sander Angle Adjustment Lever ...... 1
G. Hardware..............................One Bag
WARNING
CX503 is a heavy machine. Do not over-
exert yourself. Use a fork truck or other
mechanical devices for safe moving.
WARNING
While doing inventory, if you can not find
any part, check if the part is already
installed on the machine. Some of the
parts come preassembled on the
machine.
To Next Page
Loading...
Need help?
General
