EasyManuals Logo

Craftex CX801 User Manual

Craftex CX801
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11
TEST RUN
Once you have assembled your machine
completely, it is time for a test run to make
sure that the machine works properly and
is ready for operation.
Carefully look around your machine
before turning it on to ensure no tools are
left on the machine, all screws and knobs
are securely fastened, and all controls are
working properly.
Connect your machine to the correct
power source and turn the power switch
ON.
During the test run the machine should
run smoothly and create very little noise
or vibration. If there is an unusual noise
coming from the machine or the machine
vibrates excessively, turn the machine
OFF and investigate the problem.
ON /OFF SWITCH
This lathe is equipped with a rocker type
paddle switch to start and stop the lathe,
located at the front side of the bed. The
switch has a removable locking key to
prevent unauthorized operation. If the
lathe is not in use for long time, remove
the locking key by pulling it out and
storing it in a safe place.
To start the lathe, insert the locking key
and turn it ON. To stop the lathe, shift the
switch to the right. See Figure-9.
Figure-9 ON / OFF switch with safety key
IMPORTANT
Before a test run make sure that you
have read and understood the user
manual and you are familiar with the
functions and safety features on this
machine.
Before turning the machine on, make
sure you are wearing your safety
glasses and anyone around you is also
wearing safety glasses.
WARNING
Do not make any adjustments when
the machine is running. Failure to
follow this warning can cause a serious
personal injury.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Craftex CX801 and is the answer not in the manual?

Craftex CX801 Specifications

General IconGeneral
BrandCraftex
ModelCX801
CategoryLathe
LanguageEnglish

Related product manuals