Craftsman 247.888700 User Manual

60 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

Sears Brands Management Corporation, Hoffman Estates, IL 60179, U.S.A.

Visit our website: www.craftsman.com

CAUTION: Before using this product,

read this manual and follow all safety

rules and operating instructions.

Operator’s Manual

• SAFETY

• ASSEMBLY

• OPERATION

• MAINTENANCE

• ESPAÑOL

24” SNOW THROWER

Model No. 247.888700

Form No. 769-10888A

(May 2, 2016)

Table of Contents

Questions and Answers:

K
Kelsey RyanAug 25, 2025
Why my Craftsman Lawn Mower engine fails to start?
- J
  John PaceAug 26, 2025
  If your Craftsman Lawn Mower engine won't start, possible causes include: the PTO/Blade Engage knob is engaged (place it in the disengaged/OFF position), the parking brake isn't engaged (engage it), the spark plug wire is disconnected (connect it), the throttle control lever isn't in the correct starting position (place the Throttle lever to FAST position), the fuel tank is empty or the fuel is stale (fill the tank with clean, fresh gas that is less than 30 days old), the fuel line or fuel filter is blocked (replace the fuel line; replace the fuel filter), the spark plug is faulty (clean, adjust the gap, or replace the plug), the engine is flooded (crank the engine with the throttle in FAST position), or a fuse is blown (replace the fuse).
B
Brian NguyenAug 27, 2025
Why Craftsman Lawn Mower engine fails to start?
- B
  Brent NunezAug 27, 2025
  The Craftsman Lawn Mower engine may fail to start due to several reasons: - The blade control might be disengaged, so ensure it is engaged. - The spark plug boot could be disconnected; check and connect it. - The fuel tank may be empty or contain stale fuel; refill with fresh gasoline. - The engine may not be primed; prime it as instructed in the Operation section. - The spark plug might be faulty; clean, adjust the gap, or replace it. - The engine could be flooded; wait a few minutes before restarting.
D
Danielle CarterAug 27, 2025
What to do if Craftsman Lawn Mower engine fails to start with electric starter?
- M
  Matthew MeadowsAug 27, 2025
  If your Craftsman Lawn Mower engine fails to start with the electric starter, consider the following: - Ensure the Electric Starter Push Key is fully inserted into the starter housing until it snaps into place. - The battery may not be charged. Charge the battery. - The circuit breaker might have tripped. Stop the engine, remove the Electric Starter Push Key, and disconnect the spark plug boot. Check for and carefully remove any debris obstructing the blade. Reattach the spark plug boot and reinsert the Electric Starter Push Key. Wait one minute for the circuit breaker to automatically reset, then try starting again.
T
Teresa SullivanAug 27, 2025
How to fix a Craftsman 247.888700 when the engine fails to start?
- D
  Danny GregoryAug 27, 2025
  If your Craftsman Snow Blower engine won't start, check these potential causes: 1. Ensure the choke control is in the CHOKE position; if not, move it accordingly. 2. Verify the spark plug wire is connected; if disconnected, reconnect it. 3. Inspect the spark plug for faults; clean, adjust the gap, or replace it if necessary. 4. Check the fuel tank; if empty or the fuel is stale, fill it with fresh gasoline. 5. Prime the engine as described in the Operation section. 6. Make sure the safety key is fully inserted into the switch. 7. If using the electric start, ensure the extension cord is properly connected to both the snow blower and a grounded AC outlet.
S
Susan WilliamsonAug 28, 2025
How to fix a Craftsman Snow Blower chute that won't rotate easily?
- R
  Rhonda BowersAug 28, 2025
  If the chute on your Craftsman Snow Blower fails to easily rotate 180-200 degrees, it might be assembled incorrectly. Disassemble the chute control and reassemble it as directed in the Assembly section.
J
Jorge PriceAug 28, 2025
Why is my Craftsman Snow Blower engine running erratically?
- C
  Christina BaileyAug 28, 2025
  Your Craftsman Snow Blower may be running erratically due to several reasons. It could be running on CHOKE, so move the choke control to the RUN position. Stale fuel can also cause this issue, so fill the tank with clean, fresh gasoline. Additionally, water or dirt in the fuel system might be the problem; drain the fuel tank and refill with fresh fuel. If none of these steps work, the carburetor might be out of adjustment, or the engine might be over-governed, in that case you should contact your Sears Parts & Repair Center.
A
Amy HaysAug 29, 2025
Why is my Craftsman Snow Blower losing power?
- J
  jason77Aug 29, 2025
  If your Craftsman Snow Blower loses power, start by checking the spark plug wire to ensure it is connected and tightened properly. Also, inspect the gas cap for any blockages in the vent hole. Remove any ice or snow to ensure the vent hole is clear.
R
robyn39Aug 25, 2025
Why won't my Craftsman Snow Blower engine start?
- M
  Mary DorseyAug 25, 2025
  There are several reasons why your Craftsman Snow Blower engine might fail to start. First, ensure the choke control is in the CHOKE position. Next, check that the spark plug wire is securely connected to the spark plug. A faulty spark plug could also be the culprit, so clean, adjust the gap, or replace it if necessary. Make sure the fuel tank isn't empty or filled with stale fuel; if so, fill it with clean, fresh gasoline. Ensure the engine is properly primed as instructed in the Operation Section, and that the safety key is fully inserted into the switch. Finally, if your model has an electric start button, verify the extension cord is correctly connected to both the snow blower and a grounded AC outlet.
C
Cindy JohnsonAug 30, 2025
What to do if my Craftsman Snow Blower loses power?
- D
  Debbie VazquezAug 30, 2025
  If your Craftsman Snow Blower is losing power, check the following: * Ensure the spark plug wire is connected and tightened. * Make sure the gas cap vent hole isn't plugged; remove any ice or snow to clear it.
S
Shelia KelleyAug 31, 2025
Why is my Craftsman Lawn Mower engine overheating?
- S
  Scott LeonardAug 31, 2025
  If your Craftsman Lawn Mower engine overheats, it could be due to: low engine oil level (fill the engine with the proper amount and type of oil) or restricted airflow (clean grass clippings and debris from around the engine’s cooling fins and blower housing).

Craftsman 247.888700 Specifications

General

Brand	Craftsman
Model	247.888700
Category	Snow Blower
Language	English

Related product manuals

Preview: Craftsman 247.888701

Craftsman 247.888701

Preview: Craftsman PRO 247.888741

Craftsman PRO 247.888741

Preview: Craftsman PRO 247.888740

Craftsman PRO 247.888740

Preview: Craftsman 247.88890

Craftsman 247.88890

Preview: Craftsman 247.888500

Craftsman 247.888500

Preview: Craftsman 247.888550

Craftsman 247.888550

Preview: Craftsman 247.888301

Craftsman 247.888301

Preview: Craftsman 247.888530 Owner's g

Craftsman 247.888530 Owner's g

Preview: Craftsman Professional 247.88830

Craftsman Professional 247.88830

Preview: Craftsman 247.889571

Craftsman 247.889571

Preview: Craftsman 247.881721

Craftsman 247.881721

Preview: Craftsman 247.881732

Craftsman 247.881732