To Next PageTo Next Page
Need help?Do you have a question about the Craftsman 315.2121 and is the answer not in the manual?
General| Model Number | 315.2121 |
|---|---|
| Type | Circular Saw |
| Bevel Capacity | 45 degrees |
| Blade Diameter | 7-1/4 inches |
| No Load Speed | 5, 000 RPM |
| Arbor Size | 5/8 inch |
| Depth of Cut at 45 degrees | 1-3/4 inches |
Read all instructions for the miter saw and accessories thoroughly before use.
Carefully read the owner's manual to understand applications, limitations, and potential hazards.
Maintain a clean work area and do not leave tools or wood on the saw during operation.
Always wear safety glasses, as everyday eyeglasses are not impact-resistant.
Disconnect power before adjustments or adding accessories. Ensure switch is off when reconnecting.
Refer to these instructions frequently and loan them to other users.
Install the work clamp in the miter table base holes for workpiece control.
Fit the dust bag over the exhaust port on the upper blade guard.
Insert extensions into base holes and secure with clamp brackets and screws.
Install the stop block on table extensions for cutting multiple pieces to the same length.
Loosen the wing screw to adjust the stop block's distance from the blade.
