To Next PageTo Next Page
Need help?Do you have a question about the Craftsman 315.212120 and is the answer not in the manual?
General| Model Number | 315.212120 |
|---|---|
| Type | Circular Saw |
| Blade Diameter | 7-1/4 inches |
| Motor Amps | 13 Amps |
| No Load Speed | 5000 RPM |
| Cord Length | 6 ft |
| Bevel Capacity | 45 degrees |
| Depth of Cut at 45 degrees | 1-3/4 inches |
| Depth of Cut at 90 degrees | 2-3/8 inches |
Details the warranty terms and conditions for the product.
Explains the meaning of safety symbols used in the manual.
Explains the concept of double insulation in power tools.
Provides critical information regarding tool servicing and maintenance.
Encourages users to understand the saw's features and safety requirements.
Describes the powerful 15 amp motor with ball bearings and accessible brushes.
Specifies the included 12-inch blade and its cutting capacity.
Lists the maximum cutting dimensions at various miter and bevel angles.
Explains how to use the carrying handle for transporting the saw.
Describes the purpose and use of the spindle lock button for blade maintenance.
Details how to use the trigger lock with a padlock to prevent unauthorized use.
Explains how the miter lock handle secures the saw at desired miter angles.
Describes the lock-off lever on the switch trigger for preventing accidental starts.
Lists the preset positive stops available on the miter table.
Explains how the bevel lock knob secures the saw arm at desired bevel angles.
Describes the electric brake that quickly stops blade rotation.
Explains the function of the fence for holding the workpiece securely.
Describes the protective lower blade guard and its retraction mechanism.
Details the holes for permanently mounting the saw to a workbench.
Specifies power requirements (120V, 60Hz AC) and electrical safety precautions.
Provides instructions for installing the saw blade.
Instructions for installing the miter lock handle.
Instructions for installing the dust guide.
Details how to cut a slot in the throat plate for blade clearance.
Guides the user on how to align the miter table perpendicular to the fence.
Details how to align the saw blade parallel to the fence.
Guides the user on how to align the saw blade perpendicular to the miter table.
Discusses factory settings for arm pivot adjustments and service needs.
Checks if the saw arm rises freely and advises on service for play.
Checks if the saw arm bevels easily and advises on service for tightness or play.
Explains the function of the depth stop and its factory setting.
Provides instructions on how to adjust the depth stop for blade clearance.
Explains how to perform a straight crosscut on the workpiece.
Details the procedure for making a bevel cut with the saw.
Explains how to make a compound miter cut using both angles.
Provides guidance on supporting long workpieces for safe cutting.
Provides a chart and explanation for setting compound miter angles for various structures.
Explains how to cut crown molding accurately using miter and bevel angles.
Details how to position crown molding flat on the miter table for cutting.
Advises on positioning warped material against the fence to prevent blade pinching.
Explains how to clamp wide workpieces, like 2x6 boards, for safe cutting.
Provides advice on cleaning plastic parts and avoiding damaging chemicals.
States that bearings are pre-lubricated for life and require no further lubrication.
Discusses proper extension cord selection, use, and safety precautions.
Details the procedure for checking and replacing worn carbon brushes.
