EasyManua.ls Logo

Craftsman 315.796621 - Page 3

Craftsman 315.796621
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7. WHEN OPERATING YOUR TRIMMER --Keep extension cord behind trimmer. Never
drape it over hedge being trimmed.
8. KEEP CHILDREN AWAY-- Do not permit children to contact trimmer or extension cord.
Keep children a safe distance from work area.
9. USE TRIMMER PROPERLY -- Use only for trimming the type of shrub, growth, etc.,
described in the operating instructions, Do not abuse trimmer.
10. DON'T OVERREACH OR STAND ON UNSTABLE SUPPORT -- Keep goodfooting and
balance at all times. Do not use on ladder.
11, AVOID UNINTENTIONAL STARTING OF TRIMMER -- Before plugging in trimmer, be
sure trimmer switch is off. Don't carry trimmer with finger on switch.
12. DISCONNECT (UNPLUG) TRIMMER FROM POWER SUPPLY -- When not in use, before
servicing, cleaning, etc.
13. MAINTAIN TRIMMER WITH CARE -- Keep blades sharp at all times, and clean for best
and safest performance. Follow maintenance instructions. Always use a clean cloth
when cleaning. Never use brake fluid, gasoline, petroleum-based products, or any
strong solvents to clean your tool.
14. STORE TRIMMER INDOORS -- When net in use store trimmer indoors in a dry place
where not accessible to children.
15. DO NOT ATTEMPT TO REPAIR TRIMMER -- For service or repair return the trimmer to
your nearest Sears store. See that only identical replacement parts are used.
16. KEEP WORK AREA CLEAN -- Cluttered areas and benches invite accidents.
17.
i8: AVOID LOCKING TRIMMER SWITCH ON -- Do not use switch lock unless necessary.
Do not leave switch locked on.
19. WEAR HEARING PROTECTION DURING EXTENDED PERIODS OF OPERATION.
20. EXTENSION CORDS. -- The use of any extension cord will cause some loss of power.
To keep the loss to a minimum and to prevent tool overheating, be sure to use an exten-
sion cord heavy enough to carry the current your product will draw, For lengths less than
100 feet, No. 16 A.W.G. extension cords should be used. Follow the recommended cord
sizes on the chart below when using extension cords. If in doubt, use the next heavier
gage. The smaller the gage number the heavier the cord, For tools rated 6 amps or less:
Extension Cord Length Wire Size A.W.G.
25 Feel 18
50 Feet 16
100 Feet 16
150 Feet 14
21. TO PREVENT DISCONNECT of extension cord during operation, make knot as shown in
Fig. 8.
22. SAVE THESE INSTRUCTIONS. Review them frequently for continuing safe operation
and instructing third-party users. If you loan someone this tool, loan them these
instructions also.
Page 3

Related product manuals