Craftsman 351.217330 User Manual

Operator's Manual
CRRFT$14RN
13"
PLANER/MOLDER
Model No.
351.21 7330
CAUTION: Read and follow
all Safety Rules and Operating
Instructions before First Use
of this Product.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
www.sears.com/craftsman
17509.02 Draft (08/31/01 )

Craftsman 351.217330 Specifications

General

Brand	Craftsman
Model	351.217330
Category	Planer
Language	English

Summary

Safety Rules and Precautions

Be Prepared for Job

Wear proper apparel, safety glasses, and think clearly before operating.

Prepare Work Area for Job

Maintain a clean, well-lit work area and use proper electrical grounding.

Tool Maintenance

Assembly and Mounting

Unpacking Procedures

Check for shipping damage, report missing parts, and account for all components.

Install Handwheel Assembly

Installation and Power

Power Source Requirements

Connect only after assembly, check voltage, and use the keyed switch.

Grounding Instructions

Ensure proper electrical grounding for operator safety against shock hazards.

Operation Overview

Operation Safety Rules

Follow all safety precautions, including wearing eye protection.

Planing Procedures

Depth of Cut

Understanding depth of cut for sizing lumber and achieving a level surface.

Adjusting the Depth of Cut

How to adjust the table height using the handwheel and check the scale.

Feed Rate Adjustment

Adjusting the workpiece feed rate for optimal planing or finishing.

Planing Techniques

Avoiding Snipe

Blade Height Adjustment

Procedure for adjusting or replacing planing blades.

Blade Height Adjustment

Position the Chip Breaker

Molding Setup

Installing Cutter Bits

Mounting molding cutter bits using the bit setting gauge for precise cuts.

Installing Pattern Knives

Feed Roller Adjustment

Setting Up for Molding

General Maintenance

V-Belt Adjustment

Adjusting Table Position

Troubleshooting Common Issues

Excessive Snipe

Difficult Table Adjustment

Uneven Depth of Cut (Tapered Cut)

Planer/Molder Not Operating