:I__11/ 1 _l'I Il !,.'tI__II Izl i [e] _
WARNING: To avoid electric shock, disconnect the test leads I
from any source of voltage before removing the battery cover. J
1. Turn power off and disconnect the test leads from the meter.
2. Open the rear battery cover by removing two screws (B) using
a Phillips head screwdriver.
3. Insert the battery into battery holder, observing the correct
polarity.
4. Put the battery cover back in place. Secure with the screws.
I WARNING: To avoid electric shock, do not operate the meteruntil the battery cover is in place and fastened securely.
!
NOTE: If your meter does not work properly, check the fuses and
batteries to make sure that they are still good and that they
are properly inserted.
A A
F1 F2
11
To Next Page
Loading...
