Craftsman 82003 - Resistance Measurements

RESISTANCE MEASUREMENTS
WARNING: To avoid electric shock, disconnect power to the
unit under test and discharge all capacitors before taking any
resistance measurements. Remove the batteries and unplug
the line cords.
1. Set the function switch to the Q CAP41_-o)))
position.
2. Insert the black test lead banana plug into
the negative COM jack.
Insert the red test lead banana plug into the
positive _ jack.
3. Press the MODE button to indicate "_" on
the display.
4. Touch the test probe tips across the circuit or
part under test. It is best to disconnect one
side of the part under test so the rest of the
circuit will not interfere with the resistance
reading.
5. Read the resistance in the display.
16