Craftsman 944.364270 - User Manual

Questions and Answers

M
Mrs. Elizabeth JonesAug 2, 2025
Why is my Craftsman 944.364270 losing power?
- J
  Joseph BentleyAug 2, 2025
  If your Craftsman Lawn Mower loses power, it might be due to several reasons. Check if the rear of the mower housing or the cutting blade is dragging in heavy grass and raise the cutting height if needed. Also, avoid cutting too much grass at once by raising the cutting height. A dirty air filter can also cause power loss, so clean or replace it. Make sure to clean any buildup of grass, leaves, and trash under the mower housing. Verify that there isn't too much oil in the engine by checking the oil level, and ensure you're not walking too fast while mowing; cut at a slower pace.
L
Lynn WilsonAug 6, 2025
Why is my Craftsman 944.364270 Lawn Mower so hard to push?
- B
  brownaustinAug 6, 2025
  If your Craftsman Lawn Mower is hard to push, it could be because the grass is too high, or the wheel height is too low; try raising the cutting height. Another reason might be the rear of the lawn mower housing or cutting blade dragging in the grass, so raise the rear of the mower housing one setting higher. Additionally, check if the grass catcher is too full and empty it if necessary. Lastly, adjust the handle height to a position that suits you.
C
Cory CalderonAug 12, 2025
What to do if Craftsman 944.364270 Lawn Mower has poor cut and excessive vibration?
- S
  Scott FergusonAug 12, 2025
  If your Craftsman Lawn Mower has a poor or uneven cut and excessive vibration, inspect the blade for wear, bends, or looseness; replace the blade and tighten the blade bolt if needed. Ensure all wheel heights are set evenly. Also, clean any buildup of grass, leaves, and trash from under the mower housing.
J
Joan ShafferAug 16, 2025
Why is the starter rope hard to pull on my Craftsman 944.364270?
- J
  Jennifer LangAug 16, 2025
  If the starter rope on your Craftsman Lawn Mower is hard to pull, it could be because the engine flywheel brake is engaged when the control bar is released; depress the control bar to the upper handle before pulling the starter rope. Another possible cause is the blade dragging in grass; move the lawn mower to cut grass or to a hard surface. Finally, the blade adapter might be broken, in which case you should replace it.
B
Brenda GarzaAug 21, 2025
Why is the grass catcher not filling on my Craftsman Lawn Mower?
- C
  christian13Aug 21, 2025
  If the grass catcher on your Craftsman Lawn Mower isn't filling up, it could be due to a few reasons. Check if the cutting height is too low and raise it if necessary. Another reason could be that the lift on the blade is worn off, in which case you should replace the blade. Lastly, the catcher might not be venting air properly, so clean the grass catcher.
J
Jeffrey WintersAug 27, 2025
What causes loss of drive speed in Craftsman 944.364270 Lawn Mower?
- W
  William SmithAug 27, 2025
  If your Craftsman Lawn Mower is losing drive or drive speed is slowing, it could be due to belt wear; check and replace the drive belt if needed. Another reason may be that the belt is off the pulley; check and reinstall the drive belt. A worn or broken drive cable can also cause this issue, so replace the drive cable. Lastly, a loose drive control system might be the cause, so adjust the drive control.

Summary

Safety Rules

Children Safety

Guidelines for preventing child injury or death from lawn mower operation.

General Operation Safety

Instructions for safe operation, including area clearing and proper attire.

Slope Operation

Precautions and advice for safe operation of the mower on slopes.

Safe Handling of Gasoline

Guidelines for safe storage, handling, and use of gasoline.

General Service Safety

General advice for maintenance, repairs, and safety precautions.

Warranty Information

Product Specifications

Provides technical details and specifications for the lawn mower.

Assembly and Pre-Operation

How to Set Up Your Mower

Instructions for unfolding and setting up the mower handle.

To Remove Mower From Carton

Steps for safely removing the lawn mower from its shipping carton.

Operation

Know Your Lawn Mower

Overview of the lawn mower and its controls.

Engine Speed

Information on factory-set engine speed and adjustability.

CPSC Safety Requirements

Statement on compliance with safety standards.

How to Use Your Lawn Mower

Instructions for operating the lawn mower.

Engine Zone Control

Explanation of the operator presence control bar function.

Drive Control

How to engage and control the mower's self-propelling feature.

Drive Control Adjustment

Procedure for adjusting the drive control system for speed.

To Adjust Cutting Height

Instructions for setting the mower's cutting height.

To Convert Mower

Steps to convert the mower for mulching, bagging, or discharging.

Conversion Steps

Key steps for converting the mower for different operations.

Maintenance Schedule

Before Each Use

Tasks to perform before each use of the lawn mower.

Lubrication

Guidance on lubricating mower components.

Lawn Mower Maintenance Details

Tires

Maintenance and care instructions for the lawn mower tires.

Drive Wheels

Procedures for checking and cleaning the drive wheels.

Blade Care

Information on sharpening, replacing, and balancing the mower blade.

Engine and Storage Maintenance

Engine

Details on engine speed, carburetor, and oil requirements.

Storage

Instructions for preparing the lawn mower for long-term storage.

Grass Catcher

Care and maintenance of the grass catcher.

Gear Case

Maintenance instructions for the mower's gear case.

Engine Lubrication

Guidance on selecting and changing engine oil.

Air Filter

Instructions for cleaning or replacing the air filter.

Cleaning and Component Maintenance

Muffler

Inspection and replacement advice for the muffler.

Spark Plug

Guidance on replacing the spark plug.

Cleaning

General instructions for cleaning the lawn mower.

Water Washout Feature

Instructions on using the water washout feature for cleaning.

Clean Under Drive Cover

Procedure for cleaning the underside of the drive cover.

Service and Adjustments

To Adjust Cutting Height

Instructions for adjusting the cutting height of the mower.

Rear Deflector

Information on the rear deflector and its replacement.

To Remove Drive Belt

Steps to remove the drive belt from the mower.

To Replace Drive Belt

Steps to install a new drive belt on the mower.

To Adjust Handle

Instructions for adjusting the height of the mower handle.

Troubleshooting

Does Not Start

Troubleshooting steps for when the lawn mower fails to start.

Loss of Power

Diagnosing and fixing issues related to reduced engine power.

Poor Cut - Uneven

Solutions for problems causing an uneven grass cut.

Excessive Vibration

Addressing causes of excessive vibration during mower operation.

Starter Rope Hard to Pull

Troubleshooting difficulties with pulling the starter rope.

Grass Catcher Not Filling

Resolving issues where the grass catcher is not filling properly.

Hard to Push

Diagnosing and fixing problems that make the mower hard to push.

Loss of Drive or Slowing Drive Speed

Troubleshooting issues with the mower's drive system speed.

Craftsman 944.364270 Specifications

General

Engine Type	4-Cycle
Cutting Width	21 inches
Cutting Height	1.25 - 3.75 inches
Deck Material	Steel
Mulching Capability	Yes
Bagging Capability	Yes
Side Discharge Capability	Yes
Starter Type	Recoil
Wheel Size	7 inches (front), 8 inches (rear)