Craftsman ACCRA-ARM 113.29003 User Manual

I
i i
ASSEMBLY, OPERATING INSTRUCTIONS
AND PARTS LIST FOR
CRAFTSMAN ACCRAaARM
10 INCH RADIAL SAW
wMODEL NUMBER 113.29003
The Model Number will be found on a plate attached to your saw,
at the left side of the base. Always mention the Model Number in all
correspondence regarding the CRAFTSMAN ACCRA-ARM RADIAL SAW
or when ordering repair par_.
HOW TO ORDER REPAIR PARTS
All parts listed herein may be ordered through SEARS, ROEBUCK AND
CO. or SIMPSONS-SEARS LIMITED. When ordering parts by mall from
the mail order house which serves the territory in which you live, selling
prices will be furnished on request or parts will be shipped at prevailing
prices and you will be billed accordingly.
WHEN ORDERING REPAIR PARTS, ALWAYS GIVE THE FOLLOWING
INFORMATION AS SHOWN IN THIS LIST:
1. The PART NUMBER 3. The MODEL NUMBER 113.29003
2. The PART NAME 4. The NAME of Item--RADIAL SAW
COAST TO COAST NATION-WEDE,
SERVICE FROM SEARS
FOR YOUR CRAFTSMAN ACCRA-ARM RADIAL SAW
SEARS, ROEBUCK AND CO. and
SIMPSONS-SEARS LIMITED in Canada
back up your investment with quick,
expert mechanical service and genu-
ine CRAFTSMAN replacement parts.
If and when you need repairs or serv-
ice, call on us to protect your invest-
ment in this fine piece of equipment.
SEARS, ROEBUCK AND CO.- U. S. A.
IN CANADA, SIMPSONS_,SEAR5 L_MITED

Craftsman ACCRA-ARM 113.29003 Specifications

General

Brand	Craftsman
Model	ACCRA-ARM 113.29003
Category	Saw
Language	English

Summary

Operating Instructions and Assembly

Connecting Motor to Power Supply

Instructions for connecting the saw's motor to the electrical power supply.

Safety Precautions

Essential safety warnings and precautions for operating the radial saw.

Saw Mounting and Table Setup

Mounting the Saw to a Work Bench

Procedure for securely attaching the radial saw to a stable work bench.

Table and Fence Installation

Steps for installing the front table, fence, and rear table components.

Adjusting Table Parallel to Radial Arm

Guide on how to align the saw table parallel to the radial arm for accurate cuts.

Saw Blade and Component Alignment

Squaring Saw Blade to Table Top

Procedure to ensure the saw blade is perpendicular to the table surface.

Squaring Cross Cut Travel to Fence

Method to align the saw's cross-cut movement parallel to the fence.

Operational Procedures and Checks

Checking Saw Blade Heel (Left/Right)

Procedure to check and correct saw blade heeling for accurate cuts.

Operating Controls and Arm Movement

Radial Arm Movement and Locking

Motor and Yoke Movement Control

Adjustments for Wear and Alignment

Carriage Looseness Adjustment

Ripping Operations

In-Rip Cutting Procedure

Out-Rip Cutting Procedure