EasyManua.ls Logo

Craftsman C459-52310 - User Manual

Craftsman C459-52310
72 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Sears Canada Inc., 290 Yonge Street, Toronto, On M5B 2C3
Visit our web site: sears.ca
CAUTION: Before using
this product, read this
manual and follow all
safety rules and operating
instructions.
Operator’s Manual
TWO STAGE SNOW THROWERS
Model Nos. C459-52310 (24”)
C459-52311 (26”)
• SAFETY
• ASSEMBLY
• OPERATION
• MAINTENANCE
• PARTS LIST
11/ 27/13
769-09545
®

Table of Contents

Questions and Answers

  • B
    benjamin05Aug 12, 2025
    What to do if my Craftsman C459-52310 Snow Blower engine is running erratically?
    • S
      Sherry JonesAug 12, 2025
      If your Craftsman Snow Blower's engine is running erratically, with inconsistent RPM (hunting or surging), here's what you can do: * Ensure the engine isn't running on CHOKE by moving the choke lever to the RUN position. * If the fuel is stale, fill the tank with clean, fresh gasoline. * If there's water or dirt in the fuel system, drain the fuel tank and refill it with fresh fuel. * If the engine is over-governed, contact an authorized Service Center.
  • J
    Joseph BakerAug 16, 2025
    What to do if my Craftsman C459-52310 Snow Blower unit fails to discharge snow?
    • B
      brandonmooreAug 16, 2025
      If your Craftsman Snow Blower fails to discharge snow, here are some possible solutions: * If the chute assembly is clogged, stop the engine immediately, disconnect the spark plug wire, and clean the chute assembly and inside of the auger housing with a clean-out tool or a stick. * If there is a foreign object lodged in the auger, stop the engine immediately, disconnect the spark plug wire, and remove the object from the auger with a clean-out tool or a stick. * For the auger control cable in need of adjustment, refer to Auger Control Test. * For the auger belt loose or damaged, refer to Maintenance & Adjustments section. * If the shear pins are sheared, replace them with new ones.
  • G
    Gabriel NguyenAug 21, 2025
    Why does my Craftsman C459-52310 have excessive vibration?
    • T
      torreselizabethAug 21, 2025
      If your Craftsman Snow Blower is experiencing excessive vibration, it may be due to loose parts or a damaged auger. Immediately stop the engine and disconnect the spark plug wire. Then, tighten all bolts and nuts. If the vibration continues, have the unit serviced by an authorized Service Center.
  • M
    Megan FordAug 26, 2025
    Why is my Craftsman Snow Blower losing power?
    • G
      Gary HawkinsAug 26, 2025
      Your Craftsman Snow Blower might be losing power because the spark plug wire is loose; connect and tighten the spark plug wire. Another possible cause is a plugged gas cap vent hole; remove any ice and snow from the gas cap, and ensure the vent hole is clear.
  • T
    Thomas TurnerAug 29, 2025
    What to do if my Craftsman C459-52310 unit fails to propel itself?
    • C
      Clifford DavidAug 29, 2025
      If your Craftsman Snow Blower unit fails to propel itself, it could be due to several reasons: * The drive control cable may need adjustment; refer to the Maintenance & Adjustments section to adjust the drive control cable. * The drive belt might be loose or damaged; refer to the Service section to replace the drive belt. * The friction wheel could be worn; refer to the Service section to replace the friction wheel.
  • S
    Stephanie HunterSep 3, 2025
    How to fix a Craftsman Snow Blower chute that won't rotate?
    • T
      Tanya RaymondSep 3, 2025
      If the chute on your Craftsman Snow Blower fails to easily rotate 180 degrees, it might be assembled incorrectly. Disassemble the chute control and reassemble it as directed in the Assembly & Set-up section.
  • D
    Daniel EdwardsNov 7, 2025
    Why does my Craftsman Snow Blower engine fail to start?
    • N
      Nancy McdonaldNov 7, 2025
      Your Craftsman Snow Blower might fail to start due to several reasons: * The choke may not be in the CHOKE position, so move the choke to the CHOKE position. * The spark plug wire might be disconnected; connect the wire to the spark plug. * There could be a faulty spark plug; in this case, clean, adjust the gap, or replace the spark plug. * The fuel tank might be empty or contain stale fuel; fill the tank with clean, fresh gasoline. * The engine might not be primed; prime the engine as instructed in the Operation section. * The key might not be in the ignition; insert the key fully into the switch. * The extension cord might not be connected (when using the electric start button); connect one end of the extension cord to the electric starter outlet and the other end to a thr...

Craftsman C459-52310 Specifications

General IconGeneral
BrandCraftsman
ModelC459-52310
CategorySnow Blower
LanguageEnglish

Related product manuals