Your new tillerhas been assembled at the
factorywith exception ofthose parts left
unassembled for shippingpurposes. To
ensure safe and proper operation of your
tiller all pads and hardware you assemble
must be tightened securely. Use the correct
tools as necessary to insure proper tight-
ness.
TOOLS REQUIRED FOR ASSEMBLY
A socketwrench set will make assembly
easier. Standard wrench sizes are listed.
(1) Utilityknife
(1) Screwdriver
(1) Pair of pliers
(2) 1/2" wrenches
OPERATOR'S POSITION
When right or left hand is mentioned in
this manual, it means when you are in
the operating position (standing behind
tiller handles).
Left
Front
I
Operator's Position
Right
CONTENTS OF HARDWARE PACK
m
(1) Manual
(1) Plastic
Cable Clip
5116-18 x 1-114
(1) Reverse
Rod Bracket
B,,,c,,,,,:,!© @
(1) Washer
9132 x 1/2 x (2) Flange
! 14 Gauge Locknuts
5/16-18 UNC
(1) Cotter Pin
GG
12) Hex Nuts (2) Lock
5116-18 Washers
5/16 (1) Bottle
Engine Oil
(1) Bushing
Q
liliiiUilliiiiiiillil
(2) Carriage Bolts',
5/16-18 UNC x 2-1/2
5
To Next Page
Loading...
Need help?
General