Craftsman WS430 User Manual

15
DECORATIVE TRIMMING
When trimming around trees, posts, fences, etc., rotate the whole
unit so that the cutting head is at a 30° angle to the ground (Fig. 21).
Fig. 21
• When Using the Aero-Flex® Head: To improve performance and
maximize the life of the line blades, operate the unit at the
recommended speed when performing particular tasks:
• Trimming - Operate the unit at higher speeds.
• Decorative Trimming (against fences or other hard objects) -
Operate the unit at lower speeds.
• Edging - Operate the unit at lower speeds.
NOTE: Some line / line blade breakage will occur from:
• Entanglement with foreign matter
• Normal line / line blade fatigue
• Attempting to cut thick vegetation
• Forcing the line / line blades into objects such as walls or
fence posts
EDGING
The trimmer attachment can be used for edging (Fig. 22).
Alternatively, a bladed lawn edger attachment can also be
purchased for use with this unit.
Rotating the Trimmer Attachment
When edging around sidewalks, flowerbeds, etc., rotate the trimmer
attachment 90° inside the coupler. DO NOT rotate the entire unit 90°.
1. Turn the knob counterclockwise to loosen the coupler (Fig. 23).
2. Press and hold the release button (Fig. 23).
3. Rotate the attachment until the release button snaps firmly into
the 90° edging hole (Fig. 23).
4. Turn the knob clockwise to tighten the coupler (Fig. 23).
Maintaining the Trimming Line / Line Blades
Hard surfaces, such as sidewalks, can cause the trimming line / line
blades to wear down quickly or break.
• When Using the Bump Head: Frequently check and adjust the
trimming line length. Refer to Adjusting the Trimming Line
Length. Always keep the trimming line fully extended.
• When Using the Aero-Flex® Head: Inspect the line blades
frequently. Replace any worn or damaged line blades before
resuming operation. Refer to Replacing the Line Blades in the
Maintenance section.
• DO NOT force the unit. Make shallow cuts in as many passes as are
necessary to achieve the desired depth. Cut at a slow, even pace.
WARNING:
Only snap the release button into the 90°
edging hole when edging with the trimmer attachment.
Using the 90° edging hole with other attachments could
lead to personal injury or damage to the unit.
WARNING:
To avoid serious personal injury and
damage to the unit, shut the unit off before rotating the
attachment.
Fig. 22
Fig. 23
Release Button
90˚ Edging Hole
Knob

Craftsman WS430 Specifications

General

Brand	Craftsman
Model	WS430
Category	Trimmer
Language	English