Crane Source Space Vector SV100 - Page 18

18
120VAC Input from Pushbutton 120VAC Input from Pushbutton
Fig. 1.3.5: Pushbutton Wiring Diagrams for the Original and Revised Versions
30A 30C
30B FX BX RST CM VR V1 5G
MO EXTG RX CM P1 P2 P3 I FM 5G
Control Terminal Strip
Input Terminals For Pushbutton
Input Terminals for Pushbutton
Input Terminals for Pushbutton
FX
To jumper on circuit board
1.3.7 Connect the Pushbutton Pendant Control Wires
Wire the pushbutton pendant control to the pendant input terminals. See Fig. 1.3.5
below for wiring diagram. Once the pendant is wired, check to determine that the motor
turns in the correct direction with respect to the pendant button pressed. Consult
Chapter 4 Troubleshooting for help if there is a problem.
Note: The Interface Card requires 120 VAC input signal from your external pushbutton.
1.3.6 Interface Card Connection
The SV100 SpaceVector Drive comes equipped with the 120 VAC Interface Card
installed. Fig. 1.3.4 below shows the connection of the interface card to the control
terminal strip.
Fig. 1.3.4: Interface Card Connection to the Control Terminal Strip
TM