59
STATUS OF INPUT AND OUTPUT TERMINAL
Drive input terminal status and brake control output status can be monitored in User
Function No. 13 [InP]. This feature is a useful feature for drive trouble-shooting.
The status of selected terminals are displayed on the LED display. See Section 4.4
for a description of this feature.
SOFTWARE VERSION
vEr: Software Version
Example: H2C: Lift-Tech Software Version #2,
This is the software version of the SV100 drive
PASSWORDS
See Section 3.1 for an explanation of this feature.
5.1.4 Drive Status Monitoring
The drive operational status can be monitored via the drive keypad and Multi-Meter
output terminal.
FAULT HISTORY
User [Function Nos. 10, 11, 12]
Ft1 is the current fault if the drive is faulted and is not used when the drive is not
faulted. Drive keeps detailed fault information in two fault history parameters, plus a
memory location for the current fault, if there is one. Each fault history parameter
contains a fault code with drive status, drive output current and the frequency output
at the time of the fault. These conditions can be viewed by the using up and down
arrow keys of the keypad. See Section 4.1.2 for datailed instructions on all fault
code locations.
RESETTING A FAULT
The SV100 drive fault can be reset either from the keypad STOP/RESET button or
from the external fault reset terminal RST, or by turning power off, and back on after
approximately 3 min.
For the keypad reset, please refer to Section 4.1.2.
To Next Page
Loading...
Need help?
General