Crane S002391 - Console Button Functions (RESET;RECOVERY)

AFTER SALES SUPPORT
1800 465 070
26
service@actionspares.com.au
MODEL: S002391 PRODUCT CODE: 14498 06/2020
How To Use The Console Display (cont)
• DIST setting range: 0~99.50( press UP/DOWN to adjust, each decrease value is 0.5. Press RESET, all
value will return to zero.)
• CAL setting range: 0~9990 ( press UP/DOWN to adjust, each decrease value is 10.Press RESET, all
value will return to zero.)
• PULSE setting range: 30~240 (the preset value is 30. Press UP/DOWN to adjust, each decrease value
is 1. Press RESET, all value will return to zero.)
3. MODE KEY
• In function select mode, press MODE key to confirm function.
• In setting mode, press MODE key to confirm the setting.
• In training mode, press MODE key to stop/start.
• Every time user press MODE key it will have a beeping sound.
• In standby mode, press MODE+ SET key together for 3 seconds can power off quickly.
4. RESET KEY
• In function select mode, press RESET key will return to the previous function.
• In setting mode, press RESET key will clear the present setting value.
• In STOP mode, press RESET key will return to standby mode.
• Every time, user press RESET key, it will have a beeping sound.
• Press RESET key for 3 seconds to enter into standby mode. STROKES-TIME-DIST- CAL- PULSE will
display circularly 1 second in turn.
5. RECOVERY KEY
After training , if there is heart rate input, then press RECOVERY key, all display functions will stop
display immediately ,except TIME starts counting down from 00:60 to 00:00.
TIME display “1:00” and begin to count down.( If there is no PULSE input in count down period,it doesn’t
affect the automatic time to power off.) When it counts down to zero, LCD will only display “FX”(X value
is 1~6) in the windows.After that, if user press any key, it will skip to the normal display system.STOP，
TIME,DISTANCE,CALORIES,PULSE,TOTAL STROKES and STROKES will display the current training value.
After “FX”was displayed, press any key, After“FX”was displayed, press each key to recover to the
general display. If user press the RECOVERY button again, it will carry out again.In RECOVERY period,
press RECOVERY key can recover.
6. TOTAL RESET KEY:
Press this key, the console will enter into reboot mode directly. All data will be cleared. (The same as to
reinstall batteries.)
NOTE:
• When the display of LCD is dim, it means the batteries need to be changed.
• If there is no signal when you pedal, please check if the cable is well connected.