5. Level Platform1
33
Note: The printint platform has been leveled at the factory. If it needs leveling due to transportation or other reasons, please follow the steps
） flesruoy yb repap 4A tafl gnirb esaelP （.mroftalp gnitnirp eht tsujda ot woleb
1. To calibrate the printing platform, first raise the platform, loosen the
fixing screws on the left and right sides of the material trough, and
take out the material trough;
3. After confirming that A4 paper fits
evenly with the platform, screw up the
four screws of the platform.
2. Loosen the four Leveling screw
of the prototyping platform, attach A4
paper tightly to the print screen, press
Settings → Z Axis Motion → Levelling（Refer
to operating steps of levelling platform 2 for
operation.）, to check whether the platform
fits evenly with the paper.
To Next Page
Loading...
