[Auto Mode]： By selecting this mode,
you can sense the resin level for feeding
in real time during the printing process,
and you can set the feeding delay time to
suit your preference; you can also set the
retreat function after printing is done;
[Feed in]: click on this mode to perform
the same function as 【进料/IN】.
[Feed out]: click on this mode to perform
the same function as 【退料/OUT】.
0109
Instructions for use： Intelligent control is possible by clicking on the Halot OS function module.
The current interface is for reference only. Due to the continuous upgrading of functions,
it shall be subject to the latest software/firmware UI published on the official website.
7. Guidance on the use of the feed system/module
To Next Page
Loading...
