Create WIND BALL - Step 2. Main Body Assembly

13ENGLISH
STEP 2. MAIN BODY ASSEMBLY
++ /+ +
CHOOSE THE HEIGHT YOU NEED
A I JH L
Remove the pin from the
part I either J, depending on
the chosen height.
Enter the chosen bar through the hole in the part A.
1 2 3
A A
Insert the piece L As shown
in the picture.
With the help of a screw-
driver, remove the screws
from the top of the piece H.
Insert the bar at the top of
the part H.
Make sure no wires get
pinched.
Once the pieces are inserted A and L, you must insert the
cables of the part H inside the bar. If you wish, you can tape
the wires to make them easier to handle.
4
7 8
5 6
9
H
H
L
H
H
H