Create WIND BALL - Step 6. Fitting the Trim

18 ENGLISH
STEP 5. FITTING THE TRIM
++
G N
Using a screwdriver, remove the 3 center screws from the
motor for later use. If these screws come separately in a
sealed bag, use them for this step.
Pass the motor cables
through the hole on the side
of the piece G.
Place the piece G aligning
its holes with the holes in
the motor.
Firmly tighten the screws so that the part G is properly fas-
tened.
1
4
2
5
3
6
G
N