Create Wind Clear Rattan - Installation Check; Operational and Vibration Checks; Blade Balancing Kit Usage; Dynamic Balancing Procedure

13
ENGLISH
Your ceiling fan may have blade balance problems when operating due to irregularities in the
blades or brackets. In addition, incorrect mounting of the system or twisted bearings could
cause additional problems.
To solve these problems you must perform a dynamic balance using the provided balance kit.
Follow the procedure below:
1. Turn on the fan and set the speed at which the most sway is created (usually occurs at the
highest speed).
2. Turn off the fan. Select a blade and place the balance clip, halfway between the bracket
and the tip, on the back edge of the blade.
3. Turn on the fan. Wait to see if the rocking has improved or worsened. Turn off the fan again
and place the clip on another blade to recheck. Repeat this process with all the blades and
see which one has improved the most.
4. Place the clip on the blade that has improved the most. Move it in or out of the blade and
start the fan to nd the best position where the clip offers the most swing improvement.
5. Then remove the clip and install a balance weight on top of the blade on the center line
near the point where the clip was placed. Use a knife or blade if necessary to separate the
weights.
Watch out: Stand at a safe distance from the blades. If the clip has not been properly se-
cured, for any reason, you could be injured.
BLADE BALANCING KIT
CHECK THE INSTALLATION
• Check the correct operation of the ceiling fan, checking that there is no strange movement
or misalignment in any part of the fan.
• In the event that some type of buzzing/vibration can be seen, you can proceed to adjust the
blades with the balancing kit.
• In this kit you have self-adhesive weights and clips in the form of "u".
The CREATE app is available for both Android and iOS (search for the app on Google Play
or App Store or scan the QR code below). There may be additional costs depending on the
provider.
This device is used through your home network. As an essential requirement, you must have
a Wi-Fi network always connected to your 2.4 Gh router and the free CREATE application.
(Internet providers currently offer both 5Gh and 2.4Gh simultaneously.)
We recommend that you disconnect the appliance from the mains when you are away from
home to prevent it from accidentally starting up while you are away.
CONNECTION TO THE APP
* Only for models with Wi-Fi