Technical Specifications
0202 USB 2.0 Owner’s Manual 31
TECHNICAL SPECIFICATIONS
General
Sample Rates: 44.1, 48, 88.2, 96, 176.4, 192kHz from internal crystal
(no sample rate conversion)
Bit Depth: 24-bit I/O, 32-bit processing
USB 2.0 Hi-Speed
Full 24-bit resolution at all sample rates
2in/2 out channels
Zero-latency direct hardware monitoring
ASIO2, WDM MME
Anti-Pop speaker protection minimizes noise during power on/off
Ultra-low jitter clock subsystem
<500ps RMS in PLL mode (48kHz, Coaxial S/PDIF Sync)
Combo Microphone Preamplifier/Hi-Z/Line Input (1)
Type: Balanced E-MU XTC
®
combo mic preamplifier and Hi-Z/line input
A/D converter: AK5385A
Input Impedance: 2.5Kohms
Max Level: +6.6dBV (+8.8dBu)
EIN: (20Hz-20kHz, 150ohm, unweighted) -127dBu
Signal-to-Noise Ratio: (A-weighted, min gain) 113dB
THD+N: (1kHz at -1dBFS, min gain) -103dB (.0007%)
Gain Range: +60dB
Frequency Response: (min gain, 20Hz-20kHz) +0.0/-0.16dB
Stereo Crosstalk: (1kHz min gain, -1dBFS) < -110dB
Hi-Z/Line Input (1)
Input Impedance: 1Mohm
Max Level: +12dBV (14.2dBu)
Dynamic Range: (A-weighted, 1kHz, min gain) 113dB
Signal-to-Noise Ratio: (A-weighted, min gain) 113dB
THD+N: (1kHz at -1dBFS, min gain) -101dB (.0009%)
To Next Page
Loading...